|
Post by k1jhh on Nov 12, 2021 12:20:08 GMT -5
Unit is in very good condition. Comes with original box and instructions.
Specifications RF Power: 0 to 10, 0 to 100, 0 to 1000 Watts SWR: Calibrated from 1:1 to 3:1 Impedance: For 50/52 ohm systems only Frequency Range: 3 to 30 MHz (Useable at 144 MHz) Connectors: Coaxial SO-239 (accepts PL-259) Dimensions: 3 3/8" X 8 1/4" X 4 1/2" (HWD) (8.5 X 21.0 X 11.5 cm) (HWD) Weight: 29.3 oz (830g)
POWER Function There are three ranges of power: from 0 to 10 watts and 0-100 and 0-1000 for Ham, Citizens Band, and Commercial-type transceivers. The 3-position switch between the Meters selects the power range. Note: The Power Meter readings will be accurate only with 50/52 ohm antenna systems (or 50/52 ohm dummy loads).
SWR Function You can read SWR directly on the SWR meter. It is calibrated from 1 to 3, with a red line above 3. When the meter reads 1, the antenna system is perfectly matched to the transmitter and you have an SWR of "1" - or to be more accurate, 1 to 1 (SWR is a ratio). If your reading is more than 3, you should correct the mismatch between the transmitter and antenna system. To measure Standing Wave Ratios, set CAL/SWR switch to CAL position. Press the Push-to-talk button on your Mic. Adjust the CAL control for a reading to the SET mark on the Meter. Return the CAL/SWR switch to SWR position and read your SWR on the Meter.
$25
Contact K1JHH
|
|